SANITISING THE MIXERS
AND FOODSTUFF CIRCUITS
When installing the machine, and then at least once a week
or even more frequently according to the use of the
machine and the quality of the inlet water, the mixers and
the dispensing conduits must be thoroughly sanitised
(cleaned and disinfected), to guarantee proper hygiene of
the dispensed products.
The parts to be cleaned are as follows:
- powder deposit drawers, mixer and instant drink
dispensing conduit;
- coffee dispensing spout;
- sugar chute;
- dispensing compartment;
Fig. 4
1 - Powder feeder
2 - Powder funnel
3 - Powder deposit drawer
4 - Water funnel
5 - Feeder
6 - Mixer impeller
- remove the powder and the water funnels, the feeders,
the powder deposit drawers and the mixer wheels from
the mixers (see Fig. 4);
- in order to remove the wheels, block the disk fitted on
the mixer shaft with a finger (see Fig. 5);
Fig. 5
© by NECTA VENDING SOLUTIONS SpA
- wash all parts with detergent being sure that all visible
residue and product layers are mechanically removed,
using a brush if necessary;
Disinfection should be carried out using chlorine-based
detergents.
- soak all components for approx. 20 minutes in a
container filled with the previously prepared chlorine-
based detergent;
- reinstall the feeders and the water funnels;
- reinstall the powder deposit drawers and the powder
funnels after thoroughly drying them.
After reinstalling all parts the following is however
required:
- add a few drops of the chlorine-based detergent in the
mixer;
- using the mixer cleaning function with the door closed,
thoroughly rinse all components to ensure that all
residue of the detergent solution is removed.
MIXER CLEANING
The mixer must cleaned daily and every time the machine
is refilled to prevent clogging of the mixer if any product is
accidentally spilled during refilling.
It must be cleaned also after the mixer sanitasing opera-
tions, as described in the relevant chapter.
The mixer is cleaned with the door closed, doing as follows:
- press button 8 for 2 seconds. The display will show the
request to enter the password;
- press in a quick succession buttons 4 4 8 8 to start
cleaning.
7
03-2003 217 00
Need help?
Do you have a question about the Colibri and is the answer not in the manual?