Jandy Lite2 Installation And Operation Manual page 22

Page 20
CAUTION
Should overheating occur or the gas supply fail to
shut off, turn off the manual gas control valve to the
heater.
ATTENTION
En cas de surchauffe ou si l'alimentation en gaz ne
s'arrête pas, fermez manuellement le robinet d'arrêt
de l'admission de gaz.
CAUTION
Do not attempt repairs on the gas controls or
appliance. Tampering is dangerous and voids all
warranties.
ATTENTION
Ne tentez pas d'effectuer des réparations au
système de régulation du débit du gaz ou à
l'appareil. Toute modification non autorisée est
dangereuse et entraîne l'annulation de toutes les
garanties.
CAUTION
Keep all objects off the top of the heater. Blocking air
flow could damage the heater, and may void the
warranty.
ATTENTION
Ne posez aucun objet sur le dessus de l'appareil. Il
pourrait empêcher la circulation de l'air, ce qui
risquerait d'endommager l'appareil et d'annuler la
garantie.
WARNING
Vent pipes, draft hoods, and heater tops get hot!
These surfaces can cause serious burns. Do not
touch these surfaces while the heater is in operation.
Adding a vent cap reduces the temperature on the
top.
AVERTISSEMENT
Les tuyaux d'aération et le dessus de l'appareil
deviennent chauds! Ils peuvent causer de graves
brûlures. Ne touchez pas à ces surfaces lorsque
l'appareil est en marche.
WARNING
For your safety, when starting the heater, keep your
head and face well away from the lower firebox
opening to prevent any risk of personal injury.
AVERTISSEMENT
Pour votre sécurité personnelle lorsque vous mettez
l'appareil en marche, tenez votre tête et votre visage
loin du brûleur pour éviter tout risque de blessure.
Be sure that there is water in the pool and that
the surface level is above the skimmer or other inlet of
the pool's filter system.
Confirm that pool water is flowing normally
through the pool system and equipment. With any new
pool or spa installation, operate the filter pump with the
heater off long enough to completely clean the water.
This will remove any installation residue from the
water. Clean the filter at the end of this operation
before starting the heater. Start the heater in accor-
dance with the Operating Instructions section of this
manual, with particular attention to the lighting and
shutdown instructions and temperature control opera-
tion.
When raising the temperature of a cold pool,
remove all time clock settings. This lets the filter
system and heater operate continuously until the water
reaches the temperature setting on the temperature
control. When that happens, the heater will automati-
cally shut off, but the filter pump will keep running.
When the heater starts, immediately feel the
outlet header of the heater to confirm that there is
adequate water flow. The header should not be hot.
Normally, water temperature will rise only a few
degrees as it passes through the heater, and a "hot"
header or pipe indicates low water flow.
WARNING
When the heater is fired for the first time, the
combustion chamber refractory binder material is
driven out by the heat of the flame. White smoke
and/or sharp odors may be emitted from the vent
during this period. Do not inhale combustion product
fumes at any time, and especially when these fumes
are being emitted. This "burn-in" period will last only
a few minutes.