Advertisement
Installing the Unit
Mount to the windscreen
using suction mount and
arm.
Magnetic Antenna
Install centrally across the
width of the roof (if the roof
is not metal use the roof
mount plate supplied).
USB Power Socket
Charge the screen via supplied USB Cable.
It is recommended that the charge cable is always connected to
the screen whilst in use.
Warranty Void if suction mount fails !!
is removed from the windscreen when the unit is not in operation and
reattached on a day to day basis.
For a more permanent fixing, a mounting kit that can be secured to the vehicle is
available for an additional cost.
Warning
– Please disconnect the unit from the power
supply, if you need to jump start your vehicle.
Quick Start Guide
- Its is advised that the suction mount
Touch Screen
12v DC Plug
Plug into 3 pin
socket on vehicle.
PWdoc0007 rev.2.3
Advertisement
Table of Contents
Related Manuals for PATCHWORK BlackBox air
Summary of Contents for PATCHWORK BlackBox air
- Page 1 Quick Start Guide Installing the Unit Guidance Screen Touch Screen Mount to the windscreen using suction mount and arm. Magnetic Antenna Install centrally across the 12v DC Plug width of the roof (if the roof is not metal use the roof Plug into 3 pin mount plate supplied).
- Page 2 Setup When launching the BlackBox for the first time the ‘Setup Wizard’ will guide through the essential settings ready for guidance and area measurement. Navigation Bar Next Home Information Previous Cancel Confirm N.B. The wizard can be re-accessed via Setup > Unit Setup > Run Initial Setup Wizard.
- Page 3 Guidance Screen Start/Pause Boundary Recalibrate Guidance line Close (Straight Mode Boundary only) Recording Menu On/Off Information Panel Guidance Status Speed (Toggle Speedometer / Digital) GPS Strength Coverage Area Distance Travelled Measuring the Area of a Field 1) After starting a new job, position your vehicle at the edge of the field and press the Start/Pause Boundary.
- Page 4 Setting and Using a Guidance Line N.B. The green coverage recording can be turned off and on using the ‘Recording On/Off’ button or selected method. 1) Position the vehicle in the field where the job will begin. (When using a curved line it is important to use the longer edge of the field to set a guide line).
Need help?
Do you have a question about the BlackBox air and is the answer not in the manual?
Questions and answers