Configuration And Test Procedure - Redpine Signals RS-WC-301 User Manual

E E v v a a l l u u

4.1 Configuration and Test Procedure

1. Configure the EVB in UART mode and connect a UART cable between
the PC and the EVB.
2. Open the Serial Port Monitor to see the actual bytes exchanged. Open
Hyperterminal or Teraterm with the settings described in section
Configure Serial port in
3. Supply power to the EVB through the USB connector and put the
"Power Selection Switch" to the position as shown in the figure Error!
Reference source not found..
4. The terminal will show the message "Welcome To WiSeConnect". The
module boots up. Card Ready (LED2) glows on successful completion
of boot-up and a string "READY" is sent from module to Host. The
following commands can now be issued. Please refer to the
Programming Reference Manual for detailed description of the
commands and their responses. A command should not be sent until
the response of the previous command is received.
a. at+rsi_opermode=0
This configures the EVB to function in client mode. The module
responds with "OK"
b. at+rsi_band=0
This configures the operating band of the EVB. The module
responds with "OK"
c. at+rsi_init
This initializes the Wi-Fi module in the EVB. The module
responds with OK<MAC_Address>
d. at+rsi_fwversion?
Optional command to report the firmware version in use.
e. at+rsi_scan=0
This makes the module scan for available networks. The
module responds with information of the APs scanned.
f. at+rsi_psk=12345678
This configures the PSK of the module to connect to a security
enabled AP.
g. at+rsi_join=Test_AP,0,2
This commands the module to join to the AP "Test_AP". On
successful association, the module responds with
OK<GO_status>. The GO_status parameter can be ignored.
h. at+rsi_ipconf=0,192.168.50.10,255.255.255.0,192.168.
50.1
Redpine Signals, Inc.
R S - W C - 3 0 1
R S - W C - 3 0 1
a a t t i i o o n n B B o o a a r r d d U U s s e e r r G G u u
V e r s i o n 2 . 5 1
V e r s i o n 2 . 5 1
PC.
i i d d e e
Page 25