Crosswater SE350DC Installation Instructions

Svelte panel valves

Table of Contents

Download this manual

Enlarged version

SE350DC

Panel Valves deck mounted (pair)

Installation INSTRUCTIONS

For any further information please contact

Crosswater on: 0845 873 8840

Or visit our web-site at www.crosswater.co.uk

The manufacturer reserves the right to make technical

modifications without prior notice.

P5-H8A668-E A/0

Table of Contents

Need help?

Do you have a question about the SE350DC and is the answer not in the manual?

Page 1 SE350DC Panel Valves deck mounted (pair) INSTALLATION INSTRUCTIONS For any further information please contact Crosswater on: 0845 873 8840 Or visit our web-site at www.crosswater.co.uk The manufacturer reserves the right to make technical modifications without prior notice. P5-H8A668-E A/0...
Page 2 SE350DC INTRODUCTION DIMENSIONS Please read these instructions carefully and keep in a safe place for future reference. General Installation Requirements. The installation must comply with regulations of the Local Water Authority as contained in their bylaws. All of the taps in this range are single flow and should therefore be supplied with hot and cold water at balanced pressures, both from the tank or both from the mains (via a combination boiler for example).
Page 3 SE350DC INSTALLATION INSTALLATION First shut off your water heating system then, with your mains stop cock closed, open the lowest hot and cold taps in the house and allow to run until the cold storage tank and pipes are empty (the hot water storage cylinder always remains full).
Page 4 SE350DC CLEANING MAINTENANCE The chrome and gold plate we use on our taps is very durable, nevertheless care should be taken when cleaning them. They should be cleaned only with warm soapy water followed by rinsing with clean water and drying with a soft cloth. All finishes are vulnerable...