Cisco 1700 Series Configuring page 5

The following warning applies when this product is used in Australia.
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Warning
Incorrectly connecting this equipment to a general purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both.
Electrical Warnings
The following warnings apply when you are working with electricity:
Warning Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals.
Before opening the unit, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
Warning
tub, in a wet basement, or near a swimming pool.
Warning Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
Warning Never touch uninsulated telephone wires or terminals unless the telphone line has been
disconnected at the network interface.
Warning Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning.
To report a gas leak, do not use a telephone in the vicinity of the leak.
Warning
OL-3317-03
Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers
Safety Warnings
5