Table of Contents
Advertisement
ADCP-75-246 • Issue 1 • 6/2008
NOTE: THE MOUNTING BRACKET IS
SHOWN WITH A VERTICAL ORIENTATION.
THE MOUNTING BRACKET MAY ALSO
BE MOUNTED HORIZONTALLY IF REQUIRED.
3. Mark the location of the mounting bracket's two mounting holes on the plywood backer.
4. Drill a 3/16-inch hole in the backer board at each of the locations marked in step 3.
5. Locate the two 3/8 x 1-1/2-inch lag screws (provided with the enclosure) and place a 3/8-
inch lock washer and 3/8-inch flat washer on each screw.
6. Secure the mounting bracket to the plywood using the screws and washers prepared in step
5. Tighten screws until bracket is securely attached to the plywood.
7. Hang the enclosure from the mounting bracket as described in
Page 12
© 2008, ADC Telecommunications, Inc.
3/8-INCH FLAT
WASHER (2)
3/8-INCH LOCK
WASHER (2)
3/8 x 1-1/2-INCH
LAG SCREW (2)
Figure 5. Secure Standard Mounting Bracket To Plywood Backer
3 / 4 - I
N C H
P L Y
B A C
W O O
K E R
( S E C
D
B O A
U R E
T O W
R D
A L L
S T U
D S )
MOUNTING
BRACKET
2263-A
Section
5.4.
Advertisement
Table of Contents
