Main Power Switch - Makita DLM460 Instruction Manual

Tool / battery protection system
placed under one of the following conditions:
Overload protection
and the main power lamp blinks in green. In this situation,
turn the tool off and stop the application that caused the tool
Overheat protection
Overdischarge protection
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
1. Indicator lamps 2. Check button
light up for a few seconds.
Indicator lamps
Lighted Off
-
-
-
-
-
1
2
-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
Control panel
1
4
1.
power lamp 4. Check button 5. Mode switching
button 6. Main power switch

Main power switch

WARNING:
Always turn off the main power
switch when not in use.
machine, press the main power switch again.
NOTE: If the main power lamp lights up in red or
NOTE:
switch lever is not pulled for a certain period after the
main power switch is turned on.
9 ENGLISH
Off Blinking
malfunctioned.
2
5
2. Mode switching lamp 3. Main
Remaining
capacity
3
6