Table of Contents
Advertisement
Problems and Solutions
The following table lists possible problems and their solutions. Before calling for service, check the
information in this section to see if you can remedy any problems yourself. If you do need assistance,
please call the phone number on the warranty card,
contact your
Installation
|
Screen
1. Problems related to Installation
Problems related to the monitor installation and their solutions are listed.
It appears the PC does not
function normally.
The monitor screen flickers.
TV screen is blurred or shows
noise signals.
TV signal is not received
Strange characters appear on the
screen.
2. Problems related to Screen
Problems related to the monitor screen and their solutions are listed.
Screen is blank and power
indicator is off
"Check Signal Cable" message
"Video mode not supported"
message
Picture rolls vertically.
Image is not clear. Picture is
blurred.
Picture image is unstable and
dealer.
|
Audio
|
Remote Control
Problems
Problems
the phone number on the Information section or
Solutions
Check if the Display Adapter Driver (VGA Driver) is properly
installed. (Refer to
Installing
Check if the signal cable between the computer and the
monitor is securely connected and tightened. (Refer to
Connecting to a
Computer)
Check if the TV antenna connector is securely connected to
the external antenna. (Refer to
Check "Channel system" and make sure you choose the
correct channel system. (Refer to the
Select "Channel auto program" to configure the channel
system automatically. (Refer to the
Switch "Caption On" to "Caption Off" if strange characters
appear on the TV screen. (Refer to Caption)
Solutions
Ensure that the power cord is firmly connected and the LCD
monitor is on. (Refer to the
Connecting Your
Ensure that the signal cable is firmly connected to the PC or
video sources. (Refer to the
Ensure that the PC or video sources are turned on.
Check the maximum resolution and the frequency of the
video adaptor.
Compare these values with the data in the
Modes
Chart.
Check if the signal cable is securely connected. Connect it
again securely.(Refer to
Connecting to a
Run Frequency
Coarse
and
Turn on again after removing all accessories (video
extension cable, etc.)
Set resolution and frequency to the recommended ranges.
17 inch wide model (1280 x 768 @ 60Hz)
Check if the resolution and frequency set for the computer
Driver)
Connecting to
TV)
Channel
System)
Auto
Program)
Monitor)
Connecting Your
Monitor)
Preset Timing
Computer)
Fine
tuning.
Advertisement
Table of Contents
