Pulling Up On The Ejector Bar - BW Technologies Quattro Technical Reference Manual

6. To the left of the tab, pull up on the ejector bar.
Figure 21. Pulling up on the Ejector Bar
7. Remove the spent batteries.
8. Reset the ejector bar to its original flat position. Ensure the
ejector bar engages the release clasp.
9. Insert the new batteries. Position the positive end of the battery
at a 30° angle and insert into the battery pack before pushing
the negative end down into place. Refer to
Figure 22. Inserting the Alkaline Batteries
10. Replace the battery pack by inserting the bottom first, then
lower the top into place. Ensure the tab is tucked in before
replacing the battery pack.
11. Press until the release tab clicks. If required, tighten the retain-
ing screw using 3-4 in. lbs torque.
GasAlertQuattro
Maintenance
Figure 22.
61