Consumption Values; Fault Display - Bosch WAX16161IN Instruction Manual

Cleaning and care
Detergent solution pump
– Set the programme selector to Off, pull out the mains plug.
1. Open and remove the maintenance cover.
2. Carefully unscrew the pump cover - do not remove it completely.
3. Let the water drain into a shallow container (let the remainder drip
onto a floor cloth). Repeat the operation until there is no water left.
4. Remove the pump cover. Remove foreign material/fluff from inside the
pump.
5. Clean the interior, pump cover thread and pump housing
(fan impeller in the detergent solution pump must be able to rotate).
6. Refit the pump cover and screw on tightly.
7. Insert the maintenance cover and close it.
To prevent unused detergent from flowing into the outlet during the next
wash: pour 1 litre of water into dispenser II and start the
programme.
Filter in the water inlet hose
Reduce the water pressure in the supply hose:
1. Turn off the tap.
2. Select any programme (except Spin/Empty
3. Press Start/Soaking . Leave programme running for approx. 40 seconds.
4. Set the programme selector to Off. Pull out the mains plug.
Clean the filter:
1. Remove the hose from the tap.
Clean the filter with a small brush.
or
Remove the hose from the rear of the appliance.
Remove filter with pliers and clean.
2. Reconnect the hose and check for leaks.
– Risk of scalding. Allow detergent
solution to cool down.
– Turn off the tap.
Spin/Empty
).

Consumption values

Additional
Programme
function
Speed Wash
Cottons 40
Cottons 60 *
Speed Wash
Easy care 40
Speed Wash
40
Delicate/Silk 30 Speed Wash
Wool 30
* Programme setting for testing and energy labelling in accordance with GB standard.
** The values deviate from the indicated values depending on water pressure, hardness, and inlet
temperature, ambiente temperature,type, amount and soiling of the laundry, detergent used,
fluctuations in the power supply and selected additional functions.
Fault displays
E:17 – Tap turned on?
– Water inlet hose kinked or jammed?
– Filter blocked? Clean filter
– Water pressure too low?
E:18 – Loose debris is blocking the pump, clean the pump
– Drainage hose blocked?
Other displays Switch off the appliance, wait 5 seconds and switch it back on.
If the display appears again, call customer service.
10
Electricity con-
Load
sumption**
3,5 kg 0,53 kWh
- 6,0 kg 0,60 kWh
2,6 kg 0,39 kWh
3,0 kg 0,43 kWh
2,0 kg 0,27 kWh
- 2,0 kg 0,22 kWh
Page 10
Programme
Water**
duration**
36 l 0:55 h
45 l 4:21 h
45 l 0:51 h
32 l 0:42 h
35 l 0:38 h
35 l 0:43 h
Page 10
11