Hot Key3 (Selecting The Input) - Acer X27 User Manual

Hot key3 (Selecting the input)

Open the Input control and select HDMI1 (2.0), DHMI2 (2.0), DP IN, Mini DP and DP
ALT or Auto Source. When you are done, press the joystick to exit current page and
store.
Main Menu
Press the MENU key to open the OSD.
Toggle the joystick
toggle to the right to navigate to the element you wish to adjust and press the joystick
to enter it.
Toggle the joystick
Information Hot Key
Modes Hot Key
Exit Hot Key
X
Picture
• Brightness: Adjust the brightness from 20 to 300.
Note: Adjusts the balance between light and dark shades.
• Contrast: Adjust the contrast from 0 to 100.
Note: Sets the degree of difference between light and dark areas.
• Dark Boost: Adjust the Dark Boost from off to level3. Enhances shadows by increasing
the brightness without changing lighter shades. Note: If the image is very bright or has few
shadow.
Note: If the image is very bright or has few shadow areas, adjusting this setting may not
result in any noticeable changes to the image.
• Blue Light: Filters out blue light to protect your eyes by adjusting how much blue light is
shown -- Off, 80%, 70%, 60%, or 50%.
Note: Higher values allow more blue light through. For the best protection select a lower
value.
When "Blue Light" is on, Brightness & Contrast will show each level of "Blue Light"
value.
Input
DP
Move OK
to the up or down
to the left or right to adjust the sliding scales.
Show Monitor Information and Reset control function.
:
To change Modes Hot Key menu.
:
to exit current page and store.
Mode - Standard
Picture
Brightness
Color Contrast
Blue Light
Audio
Dark Boost
Gaming
OSD
SDR Adaptive Brightness
System
Move Enter
13
HDMI
to select Picture from the OSD.Then
240
50
Off
Off
On
X27 User Guide English