Garmin G1000 Reference Manual page 99

GIA 63W MESSAGE ADVISORIES (CONT.)
Message
HW MISMATCH – GIA hardware
mismatch. GIA1 communication halted. A GIA mismatch has been detected, where
HW MISMATCH – GIA hardware
mismatch. GIA2 communication halted.
MANIFEST – GIA1 software
mismatch, communication halted.
MANIFEST – GIA2 software
mismatch, communication halted.
MANIFEST – GFC software
mismatch, communication halted.
MANIFEST– COM1 software
mismatch, communication halted.
MANIFEST– COM2 software
mismatch, communication halted.
MANIFEST– NAV1 software
mismatch, communication halted.
MANIFEST– NAV2 software
mismatch, communication halted.
COM1 CONFIG – COM1 config error.
Config service req'd.
COM2 CONFIG– COM2 config error.
Config service req'd.
COM1 TEMP – COM1 over temp.
Reducing transmitter power.
COM2 TEMP – COM2 over temp.
Reducing transmitter power.
COM1 SERVICE – COM1 needs
service. Return unit for repair.
COM2 SERVICE – COM2 needs
service. Return unit for repair.
190-00600-04 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang
Annunciations & Alerts
Comments
only one is SBAS capable.
The GIA1 and/or GIA 2 has incorrect software
installed. The system should be serviced.
Incorrect servo software is installed, or gain
settings are incorrect.
COM1 and/or COM2 software mismatch. The
G1000 system should be serviced.
NAV1 and/or NAV2 software mismatch. The
G1000 system should be serviced.
COM1 and/or COM2 configuration settings do
not match backup configuration memory. The
G1000 system should be serviced.
The system has detected an over temperature
condition in COM1 and/or COM2. The
transmitter is operating at reduced power. If the
problem persists, the system should be serviced.
The system has detected a failure in COM1
and/or COM2. COM1 and/or COM2 may still
be usable. The system should be serviced when
possible.
83