Related Manuals for LEO ACm60
Summary of Contents for LEO ACm60
- Page 1 Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. CENTRIFUGAL PUMP Instruction Manual ACm60 / ACm75 / ACm150 / ACm150B2...
-
Page 2: Model Description
Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Congratulations on your purchase of a LEO Centrifugal Pump It is important that you read, fully understand and observe the following safety precautions and warnings. Careless or improper use of the machine may cause serious or fatal injury. The user is responsible for any accidents involving other people or other people’s property. -
Page 3: Technical Data
Protection class: F Max. ambient temperature: +40℃ Max. liquid temperature: +60℃ Type ACm60 ACm75 ACm150 ACm150B2 Power 600 W / 0,8 HP 750 W / 1,0 HP 1500 W / 2,0 HP 1500 W / 2,0 HP 1”... -
Page 4: Safety Precautions
Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Safety Precautions To ensure normal and safety operation of the electric pump, read the manual carefully before use. The electric pump should have reliable grounding to prevent short circuit; for safety, leakage protection switch should be equipped and be careful not to wet the power plug;... - Page 5 Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Keep the pump in ventilation. n case ambient temperature is lower than 4℃ or the pump is not used for a long time, empty liquid the pipeline system to avoid ice cracking of the pump chamber. Do not operate the pump for a long time without water in it.
- Page 6 Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Product Structure POS. Part POS. Part Pump body Impeller End plate Mechanical seal Capacitor Seal holder Capacitor box Pump support Terminal board Bearing Stator Rotor Bracket Spring washer Cable holder Fan cover O-sealing ring...
-
Page 7: Pipeline Installation
Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Pipeline Installation This product should be installed and maintained by personnel who is proficient in this manual and has special qualifications. Installation and operation should be in accordance with local regulations and recognized operation standards. - Page 8 Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. 1. Foot valve 2. Inlet pipe 3. Tie-in 4. Filling plug 5. Drain plug 6. Electric pump 7. Valve B: Installation precautions for inlet pipelines 1. While installing the electric pump, do not use too soft rubber tube for the inlet pipeline, avoiding to be sucked flat.
-
Page 9: Electrical Connection
Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Electrical Connection Unless the power is off, do not wiring the junction box. The electric pump should have reliable grounding to prevent current leakage with leakage protection switch being equipped Electrical connection and protection should be conducted according to stipulations. Specification of working voltage is marked on the nameplate;... -
Page 10: Start-Up And Maintenance
Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Start-up and Maintenance Do not start up the pump before the pump chamber is filled with water. Do not touch the electric pump unless its power has been cut off for at least 5 minutes. Do not dismount the pump body unless water in the pump chamber is emptied. -
Page 11: Troubleshooting
Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Troubleshooting Check the pump after power cut-off. Symptom Cause Corrective Action Single-phase power repair switch contact supply (three-phase or replace the switch; electric motor): replace the safety fuse; poor connection of check and tighten the power switch;... - Page 12 Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. The inlet pipeline is too Apply the pipe with the long or with too many stipulated diameter, bends, pipe diameter is and make the inlet pipe not selected as required. short. Insufficient pressure Inlet pipeline, filter screen Clean pipeline, foot or pump chamber is...
-
Page 13: Guarantee Terms
Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11. Guarantee terms Please carefully retain the guarantee card completed by the seller, or the proof of purchase. Pre-conditions for the 24-month guarantee entitlement: - Deployment of the device solely for private use. The guarantee is reduced to 12 months in the commercial sector or leasing business.