Peavey FX 2 16 Operating Manual page 33

Rear Panel
Media In Jacks: The Media Input jacks are set up for a +4 dBu input from a stereo audio media source.
58
The signal feeds the Media In level control (34).
Record Output Jacks: The output jacks can provide a +4 dBu output signal to a stereo recording device.
59
The output level is controlled by the Record Output level control (36).
USB Memory Connector: Use this A-type USB connector to plug in a removable data storage device to
60
read or write MP3- formatted files.
USB Computer Connector: Use this B-type USB connector to connect with a computer.
61
Power Switch: Pressing the power switch supplies power to the unit.
62
Removable Power Cord: This receptacle is for the IEC line cord (included) that provides AC power to the
63
unit. Connect the line cord to this connector and to a properly grounded AC supply. Damage to the equip-
ment may occur if an improper line voltage is used (see voltage marking on unit).
Never remove or cut the ground pin of the line cord plug. The console is supplied with a properly rated
line cord. If lost or damaged, replace this cord with one of the proper rating.
NOTE FOR UK ONLY: If the colors of the wires in the mains lead of this unit do not correspond with the colored
markings identifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow
must be connected to the terminal marked by the letter E, or by the Earth symbol, or colored green or green and
yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N, or
colored black. (3) The wire that is colored brown must be connected to the terminal that is marked with the letter
L or colored red.
63
62