Re-Arm And Anticode Reset Code - ADE Accenta G3 Engineering Information

Engineering information

Re-arm and Anticode reset code

Example: To set panel re-arms to
10 times before panel is shut down, Press:
9 9 9 9
Prog
Enter Engineer program mode
Timers and
7
Counters
Attack
Bell timer
1
Bell delay timer
2
3 Service timer
Re-arm counter
4
(00 to 99)
Anti-code reset site code
5
Zone 1
0
Zone 2
0
Day
0
9
Zone 1
0
Zone 2
0
Day
2
9
Acknowledge
Day
Exit to Timer and counters
Reset
Leave program mode
Reset
Day
Acknowledge
22
Accenta/Optima G3 Intruder system
7 4 1 0
Reset
Re-arm
After an alarm the panel will automatically reset
itself when the bell timer has expired. Any zones
which still remain open at that time will be
omitted automatically.
Anti code reset (Engineer reset)
If the system has been programmed to be
engineer reset, after an alarm it will lock out and
the RKP will continually display the cause of the
alarm. The engineer would then be required to
attend the site and use the engineer code to reset
the system.
Where anti-code reset has also been enabled, the
No re-arm
0
RKP will still show the alarm cause and also
1 re-arms
1
display a 4 digit 'quote code' by sequentially
flashing zone indicators 1-8.
3 re-arms
3
(factory default)
99 re-arms At this point the end user would contact the
9
engineer. After determining the cause of the
alarm and deciding that a engineer call was not
necessary, a 6 digit anti-code would be given to
factory
the user which would reset the system.
default
0
code
This anti-code is generated from a small
01
1
computer program which is installed at most UK
20
0
Alarm receiving Centres, or alternatively can be
run on a PC by the engineer.
99
9
Security of the anti-code reset system is
maintained by a 2 digit site code which is set up
in the anti-code generator programme. The same
2 digit site must also be set up in the control
panel during installation.
Attack
Tamper
Reset
Note: By default there are 3 automatic
re-arms before the panel is shut down.
4PI175 issue 1_6/01