Advertisement
Installation Instructions Product-Ident: 75112
12 Installation of crossover circuit
12.1 Precable crossovers - see wiring diagram.
Verstärker
empfohlene Leistung
200-300 Watt RMS / 4 Ohm
12.2 Install crossover – without housing; covered with foamed material - in the hollow space between doorboard and door card (see
fig.) and ensure precise fit.
*Important:
Protect the sheet bar against humidity and observe that the sheet bar does not touch any metal parts – danger of short
circuit!
12.3 Connect all speakers to the crossover circuit according to the wiring diagram: Series connection in parallel - cables supplied
with -
12.4 Insert woofer and midrange.
12.5 Notice: You should check the polarity of all woofers after having connected them to the crossover circuit with a 9 volt battery
(input cable on the side of the amplifier):
pole of the crossover circuit input + to + of a 9 Volt battery
pole of the crossover circuit input - to - of a 9 Volt battery
All woofers must move uniformly!
Wrong polarity of a woofer can totally equalize the bass sound!
13 Installation of the doorboard grills
13.1 Carefully press grill with Velcro fasteners onto the doorboards:
IMPORTANT: The Velcro fasteners stick very strongly!
Therefore only press the grills to the doorboard at the end of the installation of the doorboard and the soundsystem!
13.2
Further tips see attached installation recommendation.
Verstärker
empfohlene Leistung
200-300 Watt RMS / 4 Ohm
20.09.10 08:30
Seite 8 von 8
Advertisement
