Advertisement
Installation Instructions Product-Ident: 75112
5 Handling of door card cut-outs
The cut out behind the speakers are providing the required full volume of the car door:
5.1 Mark the cut outs for the woofers on the door card. Enlarge them approx. 1cm (= approx. outer diameter of the woofers)
5.2 For a plane alignment of the doorboard also mark the overlapping tray for the cut-out.
IMPORTANT! Check all cut-outs marked:
The fastenings of the doorboard must have to be screwed with the door card!
The fastenings of the door card must not be removed!
5.3 Remove the doorboard again and cut out the positions marked on the door card. Use a compass saw.
5.4 Drill the bore holes for the Spax-screws according to the marks set before - use a 5mm drill
5.5 Drill the bore holes for the M4-screws according to the marks set before - use a 4mm drill
and enlarge to 7-8mm
6 Installation of the switch for the filler unloading device
We recommend to install the switch for the filler unloading on the bottom side of the
door card.
6.1 Mark the open part, cut it out and affix the switch with 2 M4-screws.
20.09.10 08:30
Example
Example
Example
Seite 5 von 8
Advertisement
