Philips EP5934 User Manual page 23

Problem
Milk is leaking from the
milk container.
I cannot activate the
AquaClean filter and the
machine asks for
descaling.
The new water filter does
not fit.
The machine is making a
noise.
Cause
The drip tray is too full and has
overflowed which makes it
look like the machine is
leaking.
The machine is not placed on
a horizontal surface.
You did not assemble LatteGo
properly.
The filter has not been
replaced in time after the
AquaClean filter icon flashed
and the capacity dropped to
0%.
You did not install the
AquaClean filter during first
installation, but after having
brewed approx. 25 coffees
(based on 100ml cups). The
machine has to be completely
limescale-free before you
install the AquaClean filter.
You are trying to install
another filter than the
AquaClean filter.
It is normal that your machine
makes noise during use.
The AquaClean filter was not
prepared properly and air is
now drawn into the machine.
Solution
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray cover. Place the espresso stand
under the dispensing spout to collect
rinsing water.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.
Make sure that the milk container is
properly assembled to the frame of
LatteGo.
Descale your machine first and then
install the AquaClean filter.
First descale the machine and then
install a new AquaClean filter. After
descaling, the filter counter is reset to
0/8. Always confirm filter activation in
the machine menu. Also do this after
filter replacement.
Only the AquaClean filter fits into the
machine.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').
Remove the AquaClean filter from the
water tank. Shake the filter for about 5
seconds. Immerse the filter upside down
in a jug with cold water and wait until no
more air bubbles come out. Place the
prepared AquaClean filter back into the
water tank.
English
23