TP-Link CR1900 User Manual page 77

6. Please contact our Technical Support if the problem persists.
T5 How to configure MAC Clone?
You can manually change the MAC address of the modem router. It is helpful when your
internet access account provided by your ISP is bound to one specific MAC address.
In other words, your ISP just permits only one computer with the authenticated MAC
address to access the internet. In this case, you can use MAC Clone to allow more
computers to access the internet via the same account.
1. Visit http://tplinkmodem.net, and log in with the password you set for the router.
2. Go to Advanced
• If you are using the computer with the authenticated MAC address to access
the modem router, please select
• If you know the authenticated MAC address, please select
Address and then enter the address.
3. Click Save.
T6 What should I do if I cannot find my wireless network or I cannot
connect the wireless network?
¾ If you fail to find any wireless network, follow the steps below:
1. Make sure your laptop's wireless function is enabled if you're using a laptop with
built-in wireless adapter. You can refer to the relevant document or contact the
laptop manufacturer.
2. Make sure the wireless adapter driver is installed successfully and the wireless
adapter is enabled. You can refer to the relevant document or contact the wireless
adapter manufacturer.
¾ If you can find other wireless network except your own, follow the steps below:
1. Check the Wi-Fi LED indicator on your router/modem;
> Network > Internet page. Locate the Connection Settings
Clone Current Computer MAC
section.
Address.
Use Custom MAC
74