Advertisement
Installation Instructions Product-Ident: 75181
10 Mounting crossover circuit + speaker connection
10.1 Precable crossovers - see wiring diagram
Verstärker
empfohlene Leistung
200-300 Watt RMS / 4 Ohm
10.2 Install crossover in the hollow space between doorboard and door card (see fig.) and connect it with the door metal
Position: Between the 2nd and 3rd woofer behind the separating bar of the grills.
10.3 Insert woofer and midrange
10.4 Connect all loudspeakers to the crossover circuit acc. to wiring diagram: series connection in parallel - cables supplied with
10.5
In order to avoid vibration noise insulate all cables with insulation tape e.g.
10.6 Notice: You should check the polarity of all woofers after having
connected them to the crossover circuit with a 9 volt battery
(input cable on the side of the amplifier):
pole of the crossover circuit input + to + of a 9 Volt battery
pole of the crossover circuit input - to - of a 9 Volt battery
All subwoofers must move uniformly!
Wrong polarity of a subwoofer can totally equalize the bass sound!
11 Installation of the speakers grill
11.1 Carefully press grill with Velcro fasteners onto the doorboards:
IMPORTANT: The Velcro fasteners stick very strongly!
Therefore only press the grills to the doorboard at the end of the installation of the doorboard and the soundsystem!
11.2 If the grill cannot be pressed on completely on one of the fastening points ....---> see tips on the enclosed paper
Advertisement
