Operation - American Audio WM-219 User Manual

A M E R I C A N A U D I O
O P E R A T I O N – M A N U A L F R E Q U E N C Y S E T T I N G
1. Select one of the microphones and power it ON.
2. On the receiver, press the SET button for channel A or B and CH: will begin
flashing the current frequency set for that channel on the LED display.
Immediately press the SCAN or ACT buttons for the same channel (A or B) to
scroll up or down the 100 total frequency presets.
3. Press the SET button to select/lock a desired frequency for the channel (A or B).
4. Hold the desired microphone close to the wireless receiver so both the infrared
receiver on the microphone and the infrared transmitter on the wireless receiver
are in a direct unobstructed line of sight. Press the ACT button for the selected
frequency to be transmitted to the microphone.
5. Confirm the desired frequency was set by pushing the power button on the
microphone to toggle between CH and MHz on the LED display. If successful,
the CH and MHz on the receiver channel and on the microphone should match.
6. Repeat this process for the other channel and microphone or repeat this process
again if there are any issues.
7. Adjust the volume control dials for each channel (A&B) accordingly and test.
O P E R A T I O N – A U T O F R E Q U E N C Y S E T T I N G
1. Select one of the microphones and power it ON.
2. On the receiver, press the SCAN button for channel A or B and the receiver will
begin to scan for the best available frequency.
3. After the receiver completes its search and sets the frequency on the LED
Control Display, hold the desired microphone close to the wireless receiver so
both the infrared receiver on the microphone and the infrared transmitter on the
wireless receiver are in a direct unobstructed line of sight. Press the ACT button
for the selected frequency to be transmitted to the microphone.
4. Confirm the desired frequency was set by pushing the power button on the
microphone to toggle between CH and MHz on the LED display. If successful,
the CH and MHz on the receiver channel should match on the microphone.
5. Repeat this process for the other channel and microphone or repeat this process
again if there are any issues.
6. Adjust the volume control dials for each channel (A&B) accordingly and test.
13
w w w . a d j . c o m