Installation | Power | Battery Replacement - American Audio WM-219 User Manual

A M E R I C A N A U D I O
I N S T A L L A T I O N A N D P O W E R
1. Place receiver on a flat non-metal surface.
2. Connect both included UHF antennas to the back of the receiver.
3. Position both UHF antennas vertically and ensure they are fully extended.
4. Turn both Channel A and B Volume Control Dials counter-clockwise to (-).
5. Connect 3pin XLR audio cable to Balanced Channel A and B outputs.
6. Connect ¼ " audio cable to Audio Mix Out.
7. Connect included power supply to back of receiver.
8. If installing receiver in a 19-inch rack, follow steps below.
a) Connect included (2) BNC antenna extension cables to back of receiver
b) Install included (2) Rack Ears to both sides of receiver with included screw kit
c) Route antenna BNC extension cables from back of receiver to Rack Ears
d) Secure antenna BNC extension cables to Rack Ears
f) Connect ¼ " audio cable to Audio Mix Out.
e) Connect 3pin XLR audio cable to Balanced Channel A and B outputs.
g) Connect included power supply to back of receiver.
h) Install receiver into 19-inch rack space, routing cables accordingly
i) Secure receiver into 19-inch rack space with rack screws (not included)
j) Connect both included UHF antennas to the Rack Ears on each side
9. Power ON receiver.
10. P ower ON both microphones by pushing the power switch.
11. C heck battery levels of both microphones and replace batteries if needed.
M I C R O P H O N E B A T T E R Y R E P L A C E M E N T
1. Power microphone OFF.
2. Unscrew the battery compartment cover off and Insert batteries as indicated.
3. Screw on the battery compartment cover securely.
4. Power ON microphone and check battery level on LED Control Display.
12
w w w . a d j . c o m