American Standard Milano Installation & Operation

Test / Usage
1
Test
* Move handle down into "OFF"position. Turn on supply angle valve to check all connections for leak.
* Operate handle up and down, left and right to flush water lines thoroughly.
Usage
2
ON
Cold
Hot
Trouble Shooting Guide
Trouble Contents
Checkpoint
Aerator Check any impurities.
Poor flow rate Water supply valve Check valve position.
Check if hose is twisted.
Flexible hose
Cartridge packing
Check cartridge install.
Leakage
Hose junction Check the connection.
Supply Valve Check if the water from Supply valve is enough or not
Deviant
Temperature Supply system Check if the supply pipe connected correct or not
Care & Maintenance
* If you want to change the parts or clean the inner of faucet,
please follow the steps right to remove the parts.
4
1
5
1. Close the Water Supply System
6
7
Attention:
Please leave the manual with the customer
after installation is finished.
Clod
Hot
Action
Remove all impurities.
Open it to full valve
Untwist the hose.
When packing is damaged, replace the cartridge.
Check the existence of packing and wind it up sufficiently
Increase water supply
Connect the hot and cold water pipe correctly
2
3
mm
2.5
Clean Water
Aerator
Soft Brush
Remove all impurity in Aerator
- 4 -
Milano
Milano
FFAS0911-602500BF0
Single Lever Exposed B&S Mixer
FFAS0912-702500BF0
Single Lever Exposed Shower Only
Thank you for selecting American-Standard - the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin.
* American Standard always keep raising and improving the product design and performance, and reserve the right to modify
the dimension and spefication. At this case, we will not inform you separately.
* This installation instruction sheet is for your reference only, the dimension and specification is subject to the actual products.
All instruction procedures must comply in strict accordance with applicable local plumbing and building codes
Pre-Installation Checks
ON
* Remove all impurity in pipes before beginning to avoid clogging. Connect faucet pipes correctly.
Make sure the cold water hose is connected to the right side and the hot water hose to the left.
* Check installation distances in the Dimension diagram to ensure correct installation.
Conditions for use
* Recommended water pressure condition: 0.1~0.5Mpa.
* Environment Temperature:1~55℃
* Steam is not allowed to use.
* The cold and hot water pipes must not be reserved.
When in the process of installation, grab the whole body. Do not grab handle only.
Recommended Tools and Materials
Adjustable Wrench
Dimension
FFAS0911-602500BF0
240
114
+ - 15
150
70
G1/2
Rev. A1
FFAS0911-602500BF0 FFAS0912-702500BF0
Tape Measure
Level Screwdriver windtight swathe
FFAS0912-702500BF0
200
114
48
59 79
+ -
150 15
109
70
- 1 -
Installation &
Operation Instructions
Pencil Electric drill Sinker
Unit: mm
59 104
59
109
G1/2"