Ap Mode; Wps Mode - Alarm.Com ADC-V622 Quick Installation Manual

You can now power down the camera and install it in its
final location using the included hardware.
A P M O D E
To ensure sufficient Wi-Fi signal, complete these steps with
the camera near its final location but prior to mounting.
1 Connect the camera's AC power adapter and plug it into
a non-switched outlet.
2 Press the Menu button and use the Volume buttons to scroll
to the Access Point Mode (follow the audio prompts or look
for a flashing white LED).
3
Press the Menu button to activate Access Point Mode.
The LED will flash white.
4 On an Internet enabled device, connect to the Wi-Fi network
"ADC-V622 (XX:XX:XX)" where XX:XX:XX is the last six digits
of the ADC-V622's MAC address, which is located on the back
of the device near the power cord.
5 On the same device, open a web browser and enter
http://v622install in the URL field. Follow the on-screen
instructions to add the ADC-V622 to the Wi-Fi network.
The LED will be solid green when the connection is complete.
3 | ADC-V622 180° Camera with Digital Pan / Tilt / Zoom
6 Add the device to the account by either selecting the account
in MobileTech OR by using a web browser and entering the
following URL: www.alarm.com/addcamera
7 Select the camera from the video device list or type in its
MAC address to begin adding the camera. The camera's
MAC address is located on the back of the camera near
the power cable.
8 Follow the on-screen instructions to finish adding the
camera. You may configure camera settings from the
Customer Website.
You can now power down the camera and install it in its
final location using the included hardware.
W P S M O D E
1 Connect the camera's AC power adapter and plug it into
a non-switched outlet.
2 Press the Menu button and use the Volume buttons to scroll
to the WPS menu option (follow the audio prompts or look
for a flashing blue LED).
3 Press the Menu button to activate WPS Mode.
The LED will flash blue.
Quick Installation Guide | 4