FrontRow Juno Quick Setup Manual page 2

4
Install ISM-01 Student Pass-Around Microphone battery
.
1. Unscrew battery door on the back of the
microphone using the supplied Phillips head
screwdriver.
2. Locate the charge contacts on the battery
and on the microphone. See Image 1
3. Insert battery into compartment - battery contacts
first, then push the battery into place. See Image 2
4. Replace battery door.
Charging the microphone
1. Connect the USB cable to one of the Juno
Tower's charge ports and the other end to the
charge port on the microphone. See Image 3
or
2. Place in IMC-01 Charging Stand to charge battery.
See Image 4
NOTE: For best performance, charge battery
overnight before initial use.
5
Connecting PFM device to Juno Audio Out port
.
1. Connect an audio cable to the classroom audio receiver
output jack. If recording, first connect a splitter cable (1a),
then attach the audio cable (1b).
2. Turn on the student's PFM transmitter.
3. Connect the 3.5mm audio cable to the transmitter
audio in jack.
4. Set audio output volume on classroom receiver as desired
by student.
5. If recording, connect a second audio cable from the splitter
to the audio in (microphone) jack of a computer.
NOTE: The use of high quality audio cables is recommended
to avoid the introduction of interference to the system.
Tips for Specific PFM Transmitters and Classroom Amplification Receivers:
Oticon Amigo T5
On PFM transmitter,
Audio In (3.5mm)
connect cable to...
• Mute the
Notes
transmitter
Suggested Classroom Audio Output Settings (adjust as needed for student preference)
FrontRow Juno
8
FrontRow UK
Cadzow Industrial Estate, Low Waters Road, Hamilton, Lanarkshire, ML3 7QE
Image 3
Oticon Amigo T10 Oticon Amigo T30
Audio In (3.5mm Mic In (2.5mm)
• Turn the transmitter • Skip Step 3 – patch cord
OFF (don't worry; it acts as antenna
will detect the audio
• Note that the Mic in jack is
signal and transmit)
2.5mm – an adapter may be
needed or use 2.5mm to
3.5mm patch cord
8 1 / 2.5*
Moisture
Charge
Indicator
contacts
Image 1
Phonak Campus
S/SX
Audio In (3.5mm)
• Turn capsule on MM8 lapel mic
to 'X' to mute the mic
8
www.gofrontrow.com
•
Image 2
Image 4
Teacher's
Computer
5
1a
2
1b
3
Personal
FM Transmitter
Phonak Inspiro
Audio In (3.5mm)
• Turn the transmitter on first, then
• Phonak disables "Dynamic
connect for best results
FM" when connected to
classroom amplification
• Connect Aux-in audio cord to the
Juno, by connecting one 3.5mm
• Audio Input setting must
audio plug into the Audio Out socket,
be set to "iPod Nano" from
and connect the other 3.5mm audio
"General"
plug into the Roger Pen Docking
• Settings > Audio input >
Station. NOTE: the Roger Pen should
iPod nano
be switched on and paired with the
• Mute the transmitter
Roger receiver, and be docked into the
docking station.
7 / 8*
01698 208268
•
4
1
Phonak Roger Pen
Audio In (3.5mm)
6