Table of Contents
Advertisement
1. DC IN jack
Accepts connection of an AC Adaptor (PSA series; sold
separately). By using an AC Adaptor, you can play without being
concerned about how much battery power you have left.
* As soon as you connect the AC adaptor, the unit is turned on.
* We recommend that you keep batteries installed in the unit
even though you'll be powering it with the AC adaptor. That
way, you'll be able to continue a performance even if the cord
of the AC adaptor gets accidentally disconnected from the
unit.
* Use only the specified AC adaptor (PSA-series).
2. CHECK indicator
This indicator shows whether an effect is ON/OFF, and doubles
as the Battery Check indicator.
The indicator lights when an effect is ON.
* If this indicator goes dim or no longer lights while an effect
is ON, the battery is near exhaustion and should be replaced
immediately. For instructions on changing the battery, refer to
"Changing the Battery" (p. 15).
* The CHECK indicator shows whether the effect is being
applied or not. It does not indicate whether the power to the
device is on or not.
3. OUTPUT A (MONO) Jack, OUTPUT B Jack
The output jacks are used to connect the unit to amplifiers or
other devices.
* For mono output, use OUTPUT A (MONO).
* For stereo use:
OUTPUT A:
Only the processed signal is output.
OUTPUT B:
Only the dry signal is output.
4. INPUT jack
This jack accept input signal coming from a bass.
* When running the unit on battery power, the INPUT jack as
power switch. Power to the unit is turned on when you plug
into the INPUT jack; the power is turned off when the cable
is unplugged. Be sure to disconnect a cord plugged into the
INPUT jack when not using this effects device. When the AC
adaptor is used, the power remains on at all times, and this
function is disabled.
Panel Descriptions
3
Advertisement
Table of Contents
