Troubleshooting - Black & Decker PIUSB2B Instruction Manual

trOublESHOOtING

Common Problems
Problem Explanation/Recommendation
Power/Fault LED • Check that all the DC
Indicator is not lit connections are connected
correctly.
• Check the tightness of the DC
connection.
Note:
accessory outlet is "live". You
may need to turn the ignition
key to the accessory position.
Power/Fault LED When the Power/Fault LED
Indicator Lights Red Indicator turns from green
(indicating the unit is powered)
to red, a fault condition is
present and the unit will
automatically shut down. See
the Protective Features Section
of this Instruction Manual
and Common Power Output
Problems in the following
section.
PIUSB2B_ManualENFRSP_050813.indd 12-13
Make sure that your
12
Common Power Output Problems
Possible Cause Recommendation
Battery voltage Recharge battery or check DC
below 11.0 volts power supply.
Equipment being Reduce load to maximum 10
operated draws watts. Although this unit has two
too much power outlets, some phones and tablets
can draw 10 watts from a single
outlet. Connecting another device
to the second outlet in this case
would create an overload condition
and cause the charger to shut
down.
Charger in Allow charger to cool down.
thermal shutdown Ensure there is adequate
condition ventilation around the load is no
more than 10 watts for continuous
operation.
ACCESSOrIES
Recommended accessories for use with your tool are
available from the manufacturer. If you need assistance
regarding accessories, please contact the manufacturer
at 1-877-571-2391.
WARNING:
The use of any accessory not
recommended for use with this appliance could be
hazardous.
13
5/14/2013 4:17:07 PM