Hardware Setup; Quick Installation - D-Link DWR-932 Quick Installation Manual

HARDWARE SETUP

QUICK INSTALLATION

SI M
SI M
4
1. Remove the battery cover from the back of the device by
sliding it left, then remove the battery.
2. Note the SSID (network name) and password on the label
under the battery. If you want to connect to the DWR-932
wirelessly, you will need to enter this SSID and Password.
3. Slide the SIM card frame to the left and lift up. Insert the
SIM/UICC card into the SIM/UICC card slot as shown,
ensuring the gold contacts are facing down. Replace the
frame and slide it right to lock it in position.
Note: If you wish to use the onboard storage functionality,
you may install a microSD.
4. Reinsert the battery and replace the battery cover.
5. Connect the Micro USB end of the USB cable to the
Micro USB port on the bottom of the DWR-932 and plug
the other end into the USB port of the power adapter (not
included) or PC to charge the battery.
6. Press and hold the power button for five seconds to turn
on the device and proceed with either the WI-FI ROUTER
MODE or 4G USB MODEM MODE installation procedure.
DWR-932