Table of Contents
Advertisement
Installation Procedures
3. Remove the cover of the auto iris lens connector plug and solder the lens cable to
the connector pin of the plug.
• For a Video Drive Lens
Pin 1: Red (Power)
Pin 2: NC
Pin 3: White (Video Signal)
Pin 4: Black (Ground)
No. 3 Pin
No. 1 Pin
No. 4 Pin
No. 2 Pin
4. Fit the cover of the auto iris lens connector
plug, remove the protective glass cover
from the front of the camera, and fasten
the auto iris lens by turning it clockwise.
5. Set focus of camera using Back Focus Control
Lever of camera side after combining Auto
Iris lens.
Back Focus Control Lever
16
COLOR CCD CAMERA
• For a DC Drive Lens
Pin 1: Damping -
Pin 2: Damping +
Pin 3: Drive +
Pin 4: Drive -
Lens cable
connector
User's Manual
When Using C/CS Mount Lens
Before installing a lens, identify whether the lens to be installed is a C-Mount or CS-Mount.
This camera is set for a CS-Mount Lens by default. To install a C-Mount Lens, a
simple modification is required.
• When Using a CS Mount Lens
Remove the protective glass cover at the front of this product and turn the CS-
Mount Lens clockwise to install it. And set focus of camera using Back Focus
Control Lever of camera side after combining CS-Mount lens.
Notes
• Use the lens connector shown in the following figure. If the dimensions of the
connector are not correct, it may damage the camera, or the lens may not be
installed firmly.
C-Mount Lens: 10mm or less
CS-Mount Lens: 5mm or less
• If the lens is too heavy, the camera becomes unbalanced and there may be
problems. Use a lens that weighs less than 450g.
• When adjusting the Automatic Level Control (ALC) of an auto iris lens, use Av
mode if available. If you use the Pk mode, the picture brightness may change
continuously.
COLOR CCD CAMERA
17
User's Manual
Advertisement
Table of Contents
