Recharge Mower PMLI-14 Safety, Assembly, Operating And Maintenance Instructions page 16

Mower stops The battery has been completely
while mowing depleted.
(for reasons
other than
releasing the
trigger bar)
Mower is hard to The grass may be too high for the
push cutting height.
The blade, mower deck or rear
discharge plate may be clogged
with debris.
The mower bogs down or stalls in
heavy grass
The grass is wet
The battery capacity is not enough
The wheels may not be rotating
freely.
Excessive The blade may be loose
vibration or
noise
The blade may be unbalanced,
bent or damaged
Mower runs, but The battery is not fully charged
cutting
The blade may be dull
performance is
unsatisfactory,
or there is a loss
of power
The blade may be bent, loose, or
damaged
The grass may be too high or too
thick for the cutting height
Battery loses its The battery is not fully charged
power quickly
The grass may be too high or too
thick
The battery may be getting old
Grass Catcher is The grass catcher bag is full
this could indicate that the battery pack is needing
be replaced. Contact your service provider.
Recharge the battery immediately or replace it
with a fully charged battery.
Raise the cutting height or narrow your cutting
swath and try again.
Remove the safety key from the socket and
remove battery, turn the mower over on the right
side and check below the deck. Clear the debris if
necessary.
Raise the height of mower. Cut a narrower swath.
Walk more slowly.
Let the grass dry before mowing
Charge the battery or replace with a fully charged
battery.
Remove the safety key from the socket and
remove battery, turn the mower over on the right
side, and check the wheels for damage. Replace
with new wheels if necessary.
Remove the safety key from the socket and
remove battery, turn the mower over on the right
side, and check that the blade is tightly attached
or not, if not, tighten the blade.
Remove the safety key from the socket and
remove battery, turn the mower over on the right
side, remove the blade, and check its condition.
Replace with a new blade if necessary.
Charge the battery 2-3 hours to get a full charge.
Remove safety key from the socket and remove
battery, turn the mower over on the right side, and
check the condition of the blade. Sharpen or
replace the blade, if necessary.
Remove the safety key from the socket and
remove battery, turn the mower over on the right
side, and check the condition of the blade.
Sharpen or replace the blade, if necessary.
Raise the cutting height or narrow your cutting
swath and try again.
Charge the battery 2-3 hours to get a full charge.
You will need to charge the battery at least five
times to achieve maximum cutting time
Raise the cutting height or narrow your cutting
swath
The battery will need to be replaced.
Empty the grass catcher and clean it if necessary.
16