Stihl RMI 632 P Instruction Manual page 24

English
– Minimum clearance to the mowing area:
a = 19.7 in. (50 cm)
– Width of the free area: b = 17.3 in. (44 cm)
– Maximum clearance to the mowing area:
c = 39.4 ft. (12 m)
► When installing the docking station outside the mowing
area, install "search loops" to allow the robotic mower to
more easily find the docking station. Search loops are
explained later in this manual, @ 11.8.
To secure the docking station:
4
1
► For longer service life, STIHL recommends installing the
docking station in a protected, shady location.
► Select an area free of magnetic interference. For example,
never install over a metal grate or near an electrical motor,
such as a swimming pool pump.
► Ensure that the docking station is located in sufficient
proximity to reach a covered Class A GFCI receptacle with
the 33 ft. (10 m) power supply cord. Do not use an
extension cord.
► The ground selected for the docking station should be flat
and level. The base plate should not have an incline of
more than more than d = 3.2 in. (8 cm) or a downward
slope of more than e = 0.8 in. (2 cm).
► Secure the docking station (1) in position at the chosen
location using four pegs (4). Make sure the base plate fully
contacts the ground at all four corners.
22
To connect the power supply to the docking station:
WARNING
To reduce the risk of electric shock, make sure the power
supply is not plugged into the electrical socket when
handling the connector and inserting it into the docking
station. Always unplug the power supply from the electrical
socket before removing the cover of the docking station.
d
e
► Remove the docking station cover (5) by lifting it over the
tabs on each side.
6
► Fold the panel (6) forward and hold it in the open position.
► Insert the connector (7) to the left port (8) on the circuit
board of the panel as illustrated.
10 Installing the Robotic Mower
5
7
0478-131-3046-A
5
8