Xonix NX-Vario User Manual page 10

MENU 7
that the pilot could independently turn on the alarm, get acquainted with its screens and
memorize the sound and light signals. This was done, so that when the alarm turns on in flight,
the pilot should not be distracted by reading the screen, but direct effort to bring the wing out
of dangerous regime and normalize the flight.
If this option is enabled, if the rate of decline becomes greater than -0.3 m/s, an alarm will
be activated. All subsequent signals will be the same as signals given during a real flight alarm.
The only difference is that in this case, the altitude indication is based on the altitude above
sea level . This is done so that the pilot, without changing his position could check the alarm
at a height of more than 100 meters and less than 100 meters at the same time (by selecting
the pressure at sea level (QNH) to set the altitude).
When the device is turned on, this option is disabled.
MENU 8
250} by pressing the "Button 3" for a short time. The initial value after switching on the device
is "OFF". The sound signal is given based on the relative height above the start level
Use. The function will be useful for pilots who like acro. When the head most of the time looks
at the wing, or on the partner (in the case of synchronous elements), there is not always time
to look down, and the earth is rapidly approaching. This function is intended to warn the pilot
with a long beep if he passes a certain, predetermined height threshold.
MENU 9
400, 500} by pressing the "Button 3" for a short time. The initial value after switching on the
device is "OFF". The sound signal is given based on the relative height above the start level
Turn ON/OFF the falling alarm test mode. Initially, the
option was included in the menu for setting up this
mode. But in the future it was decided to leave it, so
Turning ON/OFF the long beep function when passing
through a threshold altitude (on descent). The value is
selected from the list {OFF, 20, 30, 50, 100, 150, 200,
Turning ON/OFF the long beep function when passing
through a threshold altitude (on climb). The value is
selected from the list {OFF, 50, 100, 150, 200, 250, 300,
10
.
.