Honeywell Ademco 5800SS1 Installation Manual page 2

7. Apply optional "WARNING" label to the
outside glass surface opposite the tape side
of the 5800SS1.
REPLACING THE BATTERY
1. Using a screwdriver, carefully remove the
sensor's cover.
2. Check the battery polarity orientation
before installing
(see Figure 3).
3. Insert the battery securely in the sensor.
4. Snap the sensor cover back in place.
+4
Figure 3
Regular maintenance and inspection (at least annually) by the installer and frequent testing
by the user are vital to continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular
maintenance program to the user as well as acquainting the user with the proper operation
and limitations of the alarm system and its component parts. Recommendations must be
included for a specific program of frequent testing (at least weekly) to ensure the system's
proper operation at all times.
FOR WARRANTY INFORMATION AND DETAILS REGARDING THE LIMITATIONS OF
THE ENTIRE ALARM SYSTEM REFER TO THE INSTALLATION INSTRUCTIONS FOR
THE RECEIVER/CONTROL USED WITH THIS DEVICE.
i.Il
K0011 10/01
www.PDF-Zoo.com
SPECIFICATIONS
Glass Coverage:
Plate, Laminate, Wired, Sealed Insulated,
Coated and Tempered, up to ¼" (6.35 mm) and
10 ft (3.048 m) distance from mounting
location. One sensor is required for each
separate pane of glass.
Dimensions:
1.6" H x 1.6" W x 0.8" D (40.64 mm x 40.64
mm x 20.32 mm)
Power:
Single 3V Panasonic
Duracell DLCR2 Lithium Battery
Risk of fire, explosion, and burns. Do not
recharge, disassemble, heat above 212º F (100º
C) or incinerate. Dispose of used batteries
properly. Keep away from children.
FCC ID:CFS8DL5800SS1
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
5800SS1-001-V0
(1) This device may not cause harmful
interference.
(2) This
interference
interference
undesired operation.
TO THE INSTALLER
165 Eileen Way, Syosset, NY 11791
Copyright © 2001
CR2, Sanyo CR2, or
WARNING
FCC NOTICE
device must accept any
received, including
that may cause