Back Panel; Rs232 Connector; Figure 3 - Rfs-Sp8T Back Panel; Table 1 - Rs232 Connector Pinout - Prologic Designs RFS-SP8T User Manual

Rf switch matrix
Table of Contents

Advertisement

3.0 Back Panel

Figure 3 shows the back panel of the RFS-SP8T. The RS232 connector, LAN connector,
and reset button are labeled on the chassis and visible in the graphic below. In addition, 2
LEDs indicating the LAN status (Link and Activity) are located directly above the LAN
connector.
Power is supplied to the unit using a standard instrument cord. The RFS-SP8T will
operate on a 110/220V 50/60 Hz AC power source.
Nine RF signal SMA connectors are accessible near the top of the read panel. The RF
Common (switch "pole") is to the left and is labeled "RFC". The eight RF switch
positions are identified as RF1-RF8.

3.1 RS232 Connector

A standard DB9F is located on the right side of the RFS-SP8T back panel. The
connector pinout is provided in the table below:
Pin Number
2
3
5
The RS232 port is configured for 9600 baud, 8 bits, no parity, 1 stop bit.
RFS-SP8T RF Switch Matrix Users Manual
Document number 2000481
Figure 3 – RFS-SP8T Back Panel
Signal
TX
TX
GND

Table 1 - RS232 Connector Pinout

Direction
Output
Input
7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RFS-SP8T and is the answer not in the manual?

Table of Contents