Operating And Cooking Instructions - Nexgrill 810-0018 Manual

Operating Tips
Charcoal Grid Lifter
When the grill is completely cooled, use a glove to
remove Charcoal Grid to add charcoal to the Charcoal
Pan. Do not leave the grid lifter inside the grill as it will
get too hot to handle safely.
Charcoal grid lifter
Charcoal Tray Handle Operation
By lifting the charcoal pan handle, the charcoal pan
can be raised or lowered to adjust the cooking heat at
any time during cooking. Raising the pan increases
direct heat. Lowering the pan reduces direct heat.
Raise the tray after unit has cooled down completely to
make it easier to brush left over ash into the ash tray.
Do not raise the tray higher than halfway when fully
loaded with fresh charcoal.
Ventilation Door Control Knob Operation
To open the ventilation door, pull the ventilation knob.
To adjust ventilation, move the ventilation knob to the
right or left.
Charcoal ventilation
control knob
23
Charcoal
tray handle

Operating and Cooking Instructions

READ ALL SAFTY WARNINGS AND
INSTRUCTIONS CAREFULLY BEFORE
OPERATING YOUR GRILL.
Grilling/Searing
1.Follow the instructions below carefully to build a fire.
You may use charcoal and /or wood as fuel in the
Professional Grill (See "Adding Charcoal/Wood During
Cooking" section of this manual).
WARNING:
Never use charcoal that has been pre-treated with
lighter fluid. Use only a high grade plain charcoal or
charcoal wood mixture.
If using a Charcoal Chimney Starter, follow all
manufacturer's warnings and instructions regarding the
use of their product. Start with 8-10 pounds of charcoal.
This should be enough charcoal to cook with, once the
curing process has been completed. Pull the front air
ventilator to the left halfway. When charcoal is burning
strong, carefully place hot coals in center of charcoal
pan.
WARNING:
DO NOT use grill without charcoal ash tray in place.
DO NOT attempt to remove charcoal ash tray while
tray contains hot coals.
NOTE: To extend the life of your grill, make sure that
hot coals and wood do not touch the walls of grill.
IF USING CHARCOAL CHIMNEY STARTER,
PROCEED TO STEP 4
If you choose to use charcoal lighting fluid, ONLY use
charcoal lighting fluid approved for lighting charcoal.
Do not use gasoline, kerosene, alcohol or other
flammable material for lighting charcoal. Follow all
manufacturer's warnings and instructions regarding the
use of their product. Start with 8-10 pounds of charcoal.
Placed the charcoal in center of charcoal pan.
2. Saturate charcoal with lighting fluid. With open wait
2 to 3 minutes to allow lighting fluid to soak into
charcoal. Store charcoal lighting fluid safely away from
the grill.
3. With grill lid open, stand back and carefully light
charcoal and allow to burn covered with a lighting ash
(approximately 20 minutes).