Cisco Smart+Connected Remote 250 Reference Manual page 9

Insert the power plug into a power outlet to begin recharging.
c.
For convenience, place the recharging station close to where you use your remote.
d.
Set the charging indicator on your recharging station
Step 5
This section applies to recharging stations for existing or new remotes.
Turn the recharging station over.
a.
Notice the Charging Indicator button labeled 'High, Off, and Low'
b.
Figure 9
Move the button to the desired light level.
c.
–
–
–
Turn the recharging station over to its upright position.
d.
Step 6 Place the Remote on Your Recharging Station
This section applies to recharging stations for existing or new remotes.
a. If you purchased a recharging station without a remote, ensure that you've replaced your old
batteries with the new rechargeable batteries and new cover.
b. While holding the remote in a horizontal position, place it onto the charging station.
c. Ensure that it is properly seated. The two metal plates on the back of the remote must touch the metal
pins in the recharging station
come on at the bottom of the recharging station. ().
OL-27366-02
Charging Indicator Button
High—Sets to the highest light level.
Off—Sets the light to off.
Low—Sets the light to low.
(Figure
Install and Use the Optional Recharging Kit
10). Depending on your light setting an indicator light may
Cisco Smart+Connected Remote 250 Reference Guide
(Figure 9).
9