Configure The Remote Control - Cisco Smart+Connected Remote 250 Reference Manual

Cisco Remote 250 (Offline)
If you have a Cisco Remote 250 that is offline, follow these steps:
1.
2.
3.
Press Yes.

Configure the Remote Control

Start Control4 Composer Pro and connect to a Director.
Step 1
In the System Design view, (selected by default), select the room where the Cisco Remote will reside.
Step 2
In the My Drivers tab, locate the SR-250 under the User Interface section.
Step 3
Double-click SR-250 to add the device to the project tree.
Step 4
Identify the Cisco Remote 250:
Step 5
a.
b.
c.
d.
e.
View or change the Cisco Remote properties as needed in Composer Pro. In the System Design view's
Step 6
project tree, select the System Remote Control SR-250 object to display the device's properties.
The properties include:
•
•
•
•
•
•
•
OL-27366-02
On the remote, press
List.
Press Config.
Select Recharge Station.
In the Connections view, click the Network tab.
Select System Remote Control SR-250 in the center pane.
Click Identify (or right-click and choose Identify).
When prompted to do so, press the center button four (4) times to have the device identify to the
system.
When the MAC address appears in the window, click Close.
Display Brightness—Set the light level (brightness) of the screen backlight. Choose a percentage
from 0 (Off) to 100 (full brightness).
Keypad Brightness—Set the light level (brightness) of the keypad backlight. Choose a percentage
from 0 (Off) to 100 (full brightness).
Sleep Mode—Set how long the Cisco Remote stays awake after no activity. The default setting is
15 seconds, but can be extended up to 60 seconds or can be reduced down to 0 to conserve battery
life. Select wake on movement to wake the remote when picked up.
Battery Level—Displays the current strength of the batteries.
Channel—Displays the ZigBee channel set for the SR-250, which should match the ZigBee channel
for the Cisco Controller.
Gateway—Displays the MAC address of the ZigBee Server (usually your Cisco Controller unless
you specify differently).
Network:
MAC—Displays the Cisco Remote MAC address.
–
Firmware Version—Displays the current firmware version.
–
Cisco Smart+Connected Remote 250 Reference Guide
Configure the Remote Control
11