Connection To A Network; Cable Connection; Settings Of The Dx; Other - YOKOGAWA DX1000 User Manual

Connection to a Network

Cable Connection

Settings of the DX

Other

IM 04L4B0-8E
Connect the Ethernet cable to the Ethernet port provided on the back of the DX.
Ethernet cable
IP Address, Host Information, and DNS Setting, etc.
See Section . of the Communication Interface User's Manual (IM04L41B01-17E).
EtherNet/IP Server Settings
Press MENU (to switch to setting mode), hold down FUNC for  s (to switch to basic
setting mode), and select the Menu tab > Communication (Ethernet) > Server >
Server modes.
• Server
Set EtherNet/IP to Use.
Note
The EtherNet/IP server settings can be checked on the Network Information Screen of the DX.
You can open the Network Information Screen by pressing the FUNC > Network info soft key.
When the DX is in the basic setting mode, communications are available but input/output
data is invalid.
CAUTION
Be sure to connect an Ethernet cable
with an FCC-compliant plug. Otherwise,
the MV may malfunction.
7