Printing A Demo Page; Setting Up The Network; Supported Operating Environments - Samsung CLX-6200FX User Manual

getting started
This chapter gives you step-by-step instructions for setting up the machine.
This chapter includes:
• Setting up the hardware
•

Printing a demo page

•

Setting up the network

SETTING UP THE HARDWARE
This section shows the steps to set up the hardware which is explained in
the Quick Install Guide. Make sure you read Quick Install Guide and
complete following steps.
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow
extra space to open covers and trays.
The area should be well-ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the
altitude setting to optimize your printing. See "Altitude adjustment" on
page 28 for more information.
Place the machine on a flat, stable surface so that there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
• System requirements
• Installing the software
• Machine's basic settings
2. Unpack the machine and check all the enclosed items.
3. Remove the tape holding the machine tightly.
4. Install the toner cartridge.
5. Load paper. (See "Loading paper" on page 36.)
6. Make sure that all the cables are connected to the machine.
7. Turn the machine on.
When you move the machine, do not tilt or turn it upside down.
Otherwise, the inside of the machine may be contaminated by toner,
which can cause damage to the machine or bad print quality.
PRINTING A DEMO PAGE
Print a demo page to make sure that the machine is operating correctly.
To print a demo page:
In ready mode, press and hold the OK button for about 2 seconds.
SETTING UP THE NETWORK
You need to set up the network protocols on the machine to use it as your
network printer. You can set up the basic network settings through the
machine's control panel.

Supported operating environments

The following table shows the network environments supported by the
machine:
ITEM
Network interface •
•
Network operating system •
•
•
Network protocols •
•
•
•
•
If you want to set up DHCP network protocol, go to
developer.apple.com/networking/bonjour/download/
Bonjour program that is appropriate for your computer operating
system and install the program. This program will allow you to set
network parameters automatically. Follow the instructions in the
installation window. This program does not support Linux.
REQUIREMENTS
Ethernet 10/100 Base-TX
IEEE 802.11 b/g Wireless LAN
(optional)
Windows 2000/XP/2003/Vista
Various Linux OS
Mac OS X 10.3 ~ 10.5
TCP/IP on Windows
IPP
SNMP
DHCP
BOOTP
http://
, select the
Getting started_ 25