ALDI 55902 User Manual page 12

Cordless Drill Driver Kit · 20v Lithium-Ion Battery
3. While charging, the charger may hum and become warm to touch. This is a normal occur-
rence and does not indicate a problem.
4. If the batteries do not charge properly—(1) Check current at receptacle by plugging in a
lamp or other appliance. (2) Check to see if receptacle is connected to a light switch which
turns power off when you turn out the lights. (3) Move charger and tool to a surrounding
air temperature of 40°F (4.5°C) to 105°F (+40.5°C). (4) If the receptacle and temperature
are OK, and you do not get proper charging, take or send the tool and charger to your local
service center.
5. The tool should be recharged when it fails to produce sufficient power on jobs which were
easily done previously. Battery life may be greatly diminished if batteries are discharged
deeply. DO NOT CONTINUE using product with its batteries in a depleted condition. Re-
charge discharged batteries promptly.
6. To maximize battery life:
a. Do not fully discharge batteries.
b. Fully recharge batteries after each use.
c. Store tool in a location where the surrounding air temperature is approximately
40°F-75°F (4.5°C - 24°C).
d. Disconnect charger from tool after charge is complete.
WARNING: Fire Hazard. When disconnecting the charger from the tool, be sure to un-
plug the charger from the outlet first, then disconnect the charger cord from the tool.
AFTER SALES SUPPORT
1866 902 9690
Parts List
support@merotecusa.com
12