ALDI 55902 User Manual page 11

Cordless Drill Driver Kit · 20v Lithium-Ion Battery
Charging procedure
IMPORTANT:
The battery pack is not fully charged at the factory. Before attempting to
charge them, thoroughly read all of the safety instructions.
(1) To assure that the charger you use are applicable to the battery pack.
(2) Plug the charger plug into the charging hole of the battery pack.
(3) Plug the charger into any suitable standard outlet.
(4) Let the battery pack charge initially until the green light illuminates. If all power lights are
on, the battery pack is fully charged.
Recharge discharged batteries as soon as possible after use or battery life may be greatly di-
minished. For longest battery life, do not discharge batteries fully.
It is recommended that the batteries be recharged after each use.
WARNING:
Fire Hazard. When unplug the output plug from the charging hole, be sure to
unplug the charger from the outlet first, then disconnect the charger output plug from the
charging hole.
Important Charging Notes
1. Your tool was sent from the factory in an uncharged condition. Before attempting to use it,
it must be charged.
CAUTION:
2. To reduce the risk of damage to the batteries, NEVER charge them in an air
temperature below 40°F (4.5°C) or above 105°F (40.5°C). Also, NEVER charge them if the
battery temperature is below 40°F (4.5°C) or above 105°F (40.5°C). Longest life and best
performance occurs when batteries are charged with an air temperature of approximately
75°F (24°C). NOTE: The tool will not charge if the tool temperature is below approximately
32°F (0°C) or above 113°F (45°C).
11
support@merotecusa.com
Charging hole
Safety Instructions
AFTER SALES SUPPORT
1866 902 9690