Fiberoptics Holder For Surfaces 2060-A; Mini Quantum/Temp.-Sensor 2065-M - Walz MINI-PAM-II Manual

Chapter 8
8.2.6

Fiberoptics Holder for Surfaces 2060-A

Aluminum plate (6.0 x 3.3 cm max.) with 11 mm diameter circular
hole (measuring area) and aluminum port to position fiber at an
angle of 60° relative to the aluminum plate. With port for temper-
ature sensor of 2065-M unit to measure surface temperature and
thread to mount the PAR sensor of the 2065-M unit. Connected
to a 10 x 0.8 cm (L x Ø) steal rod with two lateral aluminum sup-
ports (12 cm x 1 cm x 1 cm, L x W x H) which are lockable by
knurled screws
Dimensions (without aluminum supports): 15 cm x 3.3 cm x
2.5 cm (L x W x H)
Weight: 125 g
8.2.7

Mini Quantum/Temp.-Sensor 2065-M

Mini quantum and temperature sensors connected by 30 cm ca-
bles to an electronic unit for signal amplification, digitization and
storage of calibration factors. A 10 cm steel rod can be laterally
screwed-on to the electronic unit. A 110 cm cable connects the
2065-M unit with the fluorometer
Mini quantum sensor: LS-C sensor for selective PAR meas-
urement, range 0 to 7000 μmol m
incident at angles between -30 to +30 from surface normal
Thermocouple: Ni-CrNi, wire diameter 0.1 mm, -20 to +60 C
Dimensions of electronic unit: 15 cm x 3.3 cm x 2.5 cm (L x W
x H)
Weight: 125 g (excluding cable)
112
Specifications
-2 -1
s , cosine corrected for light