Dodge Grand Caravan 2018 User Manual page 100

Tether Strap Anchorages (Second Row
Captains Chair Anchorage Shown)
LATCH-compatible child restraint systems will
be equipped with a rigid bar or a flexible strap
on each side. Each will have a hook or connector
to attach to the lower anchorage and a way to
tighten the connection to the anchorage.
Forward-facing child restraints and some rear-
facing child restraints will also be equipped
with a tether strap. The tether strap will have a
98
hook at the end to attach to the top tether
anchorage and a way to tighten the strap after it
is attached to the anchorage.
Center Seat LATCH
If a child restraint installed in the center posi-
tion blocks the seat belt webbing or buckle for
the outboard position, do not use that outboard
position. If a child seat in the center position
blocks the outboard LATCH anchors or seat belt,
do not install a child seat in that outboard
position.
WARNING!
Never use the same lower anchorage to at-
tach more than one child restraint. Please
refer to "To Install A LATCH-Compatible
Child Restraint" for typical installation in-
structions.
Always follow the directions of the child re-
straint manufacturer when installing your child
restraint. Not all child restraint systems will be
installed as described here.
To Install A LATCH-Compatible Child Re-
straint
If the selected seating position has a Switchable
Automatic Locking Retractor (ALR) seat belt,
stow the seat belt, following the instructions
below. See the section "Installing Child Re-
straints Using the Vehicle Seat Belt" to check
what type of seat belt each seating position has.
1. Loosen the adjusters on the lower straps and
on the tether strap of the child seat so that
you can more easily attach the hooks or
connectors to the vehicle anchorages.
2. Place the child seat between the lower an-
chorages for that seating position. For some
second row seats, you may need to recline
the seat and / or raise the head restraint to
get a better fit. If the rear seat can be moved
forward and rearward in the vehicle, you may
wish to move it to its rear-most position to
make room for the child seat. You may also
move the front seat forward to allow more
room for the child seat.
3. Attach the lower hooks or connectors of the
child restraint to the lower anchorages in the
selected seating position.