Table of Contents
Advertisement
Chapter 2: Installation
Display Unit Connection
The rear of the HSB Series LCD display provides the following connection
sockets:
• Transducer connection.
• HSB, in/out connector for connecting to another HSB Series display (such
as a radar or second Fishfinder display).
• SeaTalk, for SeaTalk data input and output and connecting to another HSB
Series display (such as a radar or second Fishfinder display).
•
NMEA Output, for NMEA data output in an integrated system.
• Power/NMEA Input, for 12 V, 24 V or 32 V DC power connection, two
NMEA 0183 inputs and one RF ground (screen) connection.
Figure 2-22: Fishfinder Display Connector Panel
The following sections detail the display unit connectors used when installing
a single HSB Series LCD Display. The remaining connector details are
provided in Section .
Transducer Connection (master displays)
Before attaching it to the display, you will need to attach the connector nut and
split ring to the transducer cable. These items, plus a wedge tool, are included
in the transducer packaging.
CAUTION:
Take care not to pull on the cable – this can damage the transducer wires.
1. Feed the cable/connector through the 3/4" (19mm) diameter hole in the
surface where the display is mounted.
2. Slip the nut over the connector and push it past the connector and over the
cable.
3. Insert the wedge tool into the groove in the split of the split ring and slide
the wedge tool until its squared end is flush with the larger edge of the split
ring.
2-31
D4849-1
Hide quick links:
Advertisement
Table of Contents
