Using Tracks - Raytheon HSB L760 Owner's Handbook Manual

Chapter 5: Standard Chart Operations

5.7 Using Tracks

The Track function is used to mark on-screen the trail that your vessel has
followed, as if it had left a visible fixed wake.
While the track is turned on, it is recorded in the display unit's memory. You
specify the interval at which track points are made, a line is drawn on-screen
between each point. Up to 4500 track points can be saved in total, in up to 5
track files (each a maximum of 750 points).
The track remains on-screen, even following a power off/on, until you clear
the track.
A track can be saved and retrieved for display at a later date. For example, you
may wish to display a previous track, and then place waypoints along it that
you can follow. You can only display one track at a time; you must clear a
current track from the screen if you want to display a saved track.
This section describes:
• Setting up a track, including how to specify the interval.
• Clearing the current track.
• Managing tracks, using the track list, including Saving, Naming, Erasing
and Showing a track.
➤
To access the track controls:
1. From the chart display, press the MENU key to display the chart set up soft
keys.
2. Press the TRACK SETUP soft key to display the Track soft keys:
TRACKS
OFF ON
The following instructions assume you have the track soft keys displayed.
SYSTEM CHART
SET UP! SET UP!
CLEAR
TRACK
TRACK GPS
SET UP! SETUP!
TRACK TRACK
LIST INTERVAL
D4179-1
5-31
D4162-1