General Troubleshooting - Raw Thrills Jurassic Park Arcade Operator's Manual

Operator's Manual
Troubleshooting
Warning: Review safety chapter before making any adjustments to game.
General Troubleshooting
Problem
Game will not power up
Screen not powering on with game
NO VIDEO message
No sound
Game does not load
Hard drive test reports "bad" or
"missing" files.
Game fails to finish loading.
After resetting, game still reports an
error.
Game suggests inserting a boot
DVD.
Erratic game mode or attract mode.
WARNING!
Data Files Corrupted.
(Game Operation May Become
Unstable.)
Use "Test" Switch to Enter Test
Mode
and Run "File Test."
Press Start To Continue.
Jurassic Park ™© is a trademark and copyright of Universal Studios and Amblin Entertainment, Inc. Licensed by Universal Studios
Licensing LLC. All rights reserved. Jurassic Park Arcade Game Software Copyright 2014 Raw Thrills, Inc. All rights reserved.
Possible Cause
Game not plugged in.
Game not turned on.
Game fuse is blown.
No power to receptacle.
PC not turned on.
PC BIOS set incorrectly.
No AC power or bad video cable
Video cables not plugged in properly
PC did not power up
Faulty video cable
PC not turned on.
Bad Connection from PC to RIO
audio or bad speaker connection.
Hard drive failure
Solution
Plug game into outlet.
Turn on main power switch.
Check and replace fuse.
Test outlet and plug game into
powered outlet.
Turn PC power switch on. Ensure
IEC cable tightly plugged in. Trace
cable back to source to ensure
continuity.
See BIOS Settings chapter.
Check loose or bad AC or video
connection
Reattach and/or tighten video cable
to monitor.
Reattach and/or tighten video cable
to PC. Power cycle PC or game
Replace video cable
Turn PC power switch on.
Check connection ¼" stereo cable
from PC to RIO and speakers.
Recover hard drive.
Page | 19