Kenwood TS-890S Command Reference Manual page 20

Bandscope Display Information (AI function not linked, with
DD4
Scope mode and Scope range information)
1 2 3
D D 4
Answer 1
29 30
P5 ;
1 2 3
Answer 2
D D 4
DF
⊿F Display
1 2 3
Read
D F ;
1 2 3
D F P1
Answer
11 12 13
P3 P3 P3
DM0
Dimmer
1 2 3
Set
D M 0
1 2 3
Read
D M 0
1 2 3
Answer
D M 0
PC Control Command referenCe guide
4 5 6 7~17
P1 P1 P2 P3
46
4 5 6~45
P1 P1 P6 ;
4 5 6 7 8
4 5 6 7 8
P2 P3 P3 P3 P3
14 15 16 17 18
P3 P3 ;
4 5 6 7 8
P1 ;
4 5 6 7 8
;
4 5 6 7 8
P1 ;
Parameters:
P1 (Split number)
18~28 0 ~ 32
P2 (Operation mode of Bandscope)
P4
0: Center mode
1: Fixed mode
2: Auto scroll mode
P3 (Scope range information 1)
In Center mode, the span frequency will notify you.
In Fixed or Auto scroll mode, the Lower limit frequency of the
scope will notify you.
Unit is Hz, blank digits must be entered as "0".
P4 (Scope range information 2)
In Center mode, the current center frequency will notify you.
In Fixed or Auto scroll mode, the upper limit frequency of the
scope will notify you.
Unit is Hz, blank digits must be entered as "0".
P5 (Scope display out of range information)
0: In range
1: Out of range ("Outside of the measuring range" is displayed
on the scope screen)
P6 (Band scope spectrum display information)
20 spectrum information are each expressed as 2 ASCII digits.
2 digits of the beginning of division No. 01 are Spectrum
information of the lower limit frequency of the scope range, and
two digits of the end of division No. 32 are Spectrum information
of the lower upper frequency of the scope range.
The range of value for each spectrum information is from 00h ~
8Ch (hexadecimal numbering).
00h shows the state where the spectrum is extended to the
top (signal strength = 0 dB) and 8Ch shows a state where the
spectrum is not displayed (signal strength = -100 dB).
The respective spectrum information is converted to ASCII code
of the hexadecimal number of from the upper byte digits. For
8Ch, the order becomes "8", "C".
• When the DD0 command set to "Output to COM / USB
(AI function linked)", it is output from division No. 00 to 32
sequentially.
• In the Center mode and Auto scroll mode, this command is not
output when the EXPAND function is ON.
• This command operates only at a baud rate of 115200 bps.
Parameters:
P1 (State)
9 10
0: Simplex mode
1: During split mode or split frequency operation
P2 (Code)
9 10
0: Plus
P3 P3
1: Minus
 When P1 is 0, P2 also becomes 0.
19 20
P3
11 digit frequency in Hz
 Enter unused digits as "0".
 When P1 is set to "0", all digits are returned as "0".
Parameters:
P1 (Dimmer preset number)
9 10
1 ~ 4
9 10
9 10
– 19 –