Adjusting Pump Pressure; Cleaning Carpet; Cleaning Tile And Grout - Edic ENDEAVOR Owner's/Operator's Manual

ADJUSTING PUMP PRESSURE:

This machine is equipped with a pressure regulator (see
#5 on page 7), that allows the operator to adjust the pres-
sure between 100PSI and 500PSI.
To adjust pressure:
1. Turn Pump switch to on position. Position "l".
2. Check current pressure on pressure gauge. (#4 on
page 7)
3. To increase pressure, turn the regulator in a
clockwise motion. Watch the gauge and stop
rotating the regulator when the desired pres-
sure has been reached. Max pressure is 500PSI.
P
4. To decrease pressure, turn the regulator in a count-
er-clockwise motion. Watch the gauge and stop
rotating the regulator when the desired pressure
has been reached. Minimum pressure is 100PSI.
P
Note: Do not adjust the pressure while spraying.
Adjusting the pressure, while spraying, will cause the
pump to over-pressurize and place excess load on the
pump motor. Do not exceed 500PSI. Take care when
reducing the pressure below 100PSI as the regulator
adjuster nut may come off the threaded regulator
shaft.
HOW TO SETUP THE ENDEAVOR FOR
CLEANING CARPET OR UPHOLSTERY:
1. Plug in power cords as per instructions on page 8.
2. Make sure you are on 2 circuits.
3. Connect your solution and vacuum hoses to ma-
chine and accessories.
4. Fill the machine with water. See page 10 for auto fill
instructions.
5. Prime the pump as per instructions on page 10.
6. Adjust the pressure to desired pressure between 100-
500psi. See instructions for adjusting pressure on
page 11.
7. Prespray the carpet or fabric as necessary.
8. Turn on the vacuum motor.
9. Spray on the backstroke and do a dry stroke when
pushing forward.
10. Overlap your previous path slightly when you pull
back.
11. Monitor the levels in the recovery tank and empty
as necessary. Use defoamer to ensure your vacuum
motor does not take in fluid
11