Pt100 Trip Temp -50; User Defined Trip Time 0.0; User Defined Out 0 - ABB PSTX30 Installation And Commissioning Manual

External thermal sensor - PT100
7.15.14.2
protection
The external thermal sensor has detected a temperature
higher than the trip level.
The softstarter has a temperature input where a PTC
element can be connected. This can be configured to trip
if it goes above a certain temperature.
Check the root cause of the overheating.
External thermal sensor - PT100 protection
is configured with the following parameters:
Parameter
10.11 Ext therm sensor - ID
17.03 PT100 2wire res
17.04 PT100 trip temp
17.05 PT100 PT100 reset temp
17.06 PT100 out
7
17.07 PT100 op
7.15.15 User defined protection
Programmable digital input can be used in combination
with external device/sensor to provide to the customer the
possibility of handling their own defined protection.
User defined protection is configured with the
following parameters:
Parameter
18.01 User defined DI status
18.02 User defined trip time
18.03 User defined out
18.04 User defined op
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Description
Sets the External thermal sensor
modes.
Sets the two wire resistance for
PT100.
Sets the PT100 trip temperature
level.
Sets the PT100 reset temperature.
Specifies the Event groups this
protection belongs to.
Sets the operation of this protection. Off, Stop manual,
Description
Sets if the signal is active high or
active low.
Sets the time to trip.
Specifies the Event groups this
protection belongs to.
Sets the operation of this protection. Off, Stop manual,
Setting range Default value
No sensor, PTC, No sensor
PT100-3Wire,
PT100-2Wire,
Thermistor switch.
0 ... 100 Ohm 100 Ohm
-50° ... 250° 60°
-50° ... 250° 40°
Eventgroup 0 ... 6 2
Off
Stop auto, Indication.
Setting range Default value
0 ... 1 1
0.0 ... 60.0 s 1.0 s
Eventgroup 0 ... 6 2
Off
Stop auto, Indication.